Got questions?
You’re in the right place.
Whether you’re exploring solar for the first time, looking into battery storage, EV charging or Sentinel energy optimisation, we’ve put together clear answers to the questions we’re asked most often. If you can’t find what you’re looking for, our team is always happy to help. Get In Touch
Systems can get disconnected from the internet for many reasons! Most commonly being that you have installed a new Wi-Fi hub, but even if not, some loggers need a refresher of what network they should be connected to. There are guides below that are tailored to your system’s needs. If you are struggling to follow any of these steps, please feel free to contact our technical support team by raising a ticket on www.hsenergy.co.uk/help.
Guide for SoFar inverters:
Guide for Solis inverters:
Guide for FOXESS inverters: Download guide (PDF)
Guide for Growatt inverters:
Guide for SolarEdge inverters:
Guide for EcoFlow inverters: View guide
If your system has detected an alarm within the battery then we always recommend a reset procedure to get the batteries working again or to help diagnose further faults. We often find that batteries struggle in the winter months when there is limited sunshine and high usage which will often take the battery past its limits and often run it down until it’s unable to charge again when the sunshine is better. We find that a really good way to combat this is to set charging times up throughout the night/cheap rates that you may be eligible for. Please check this with your electricity provider before programming charging times on your inverter. Please find instructions for charging and discharging times on our other FAQs.
Battery reset procedure for SoFar inverters: Download guide (PDF)
Battery reset procedure for Solis inverters: Download guide (PDF)
Battery reset procedure for FOXESS inverters: Download guide (PDF)
There is usually no need to clean your solar panels. Due to the natural tilt on all roofs, including flat roofs, surface run-off should occur causing the panels to clean from rainfall. Of course, there is the issue of stubborn stains such as bird droppings etc. If your panels remain visibly dirty for a long time then there’s no harm in getting them cleaned. Unfortunately, at this moment in time, we do not provide a cleaning service but this is something we are looking into in the future. We do not have any personal recommendations for cleaners but you can always use the link below for trusted cleaners in your area:
Find a trusted solar panel cleaner on Checkatrade
If you plan to clean your solar panels by yourself then please use rubber gloves, water only and a soft brush to not damage the panels.
Unfortunately, solar panels will always be producing live DC current and can give small shocks when interacting with water. If you have to clean your panels for whatever reason we would always suggest using rubber gloves and non-conductive cleaning apparatus. Do not use any chemical products on the panels as this can damage their silicone coating.
Battery Charging Guide for Solis inverters:
Battery Charging Guide for SoFar inverters: Download guide (PDF)
Battery Charging Guide for FOXESS inverters: Download guide (PDF)
Battery Charging Guide for EcoFlow inverters: Download guide (PDF)
In case of an emergency please turn off your red AC isolator switch and, if visible, turn the system off at the fuseboard.
Check the screen on your power diverter to see if it gives an error message. If the message says “lost signal to sender unit”, then follow the procedure below. If there is no apparent reason for the fault then please send pictures of your power diverter to TSA@hsenergy.co.uk for further assistance.
Your power diverter runs off excess solar energy to power your hot water. The system requires a “sender unit” which will be in your electrical meter cupboard, which reads the excess solar generation in order for the power diverter to work. Unfortunately, these sender units cannot be hard-wired in and run off two AA batteries that may need to be replaced. The cover should pop off and the batteries should be easy to switch out. After this is done you can check the display on the main unit to see if it has paired. If it hasn’t then press and hold the button on both the sender unit and the display button on the main unit to pair. You may need two people to do this or be quick on your feet!
If the system still doesn’t pair or you need further assistance then please raise a ticket on www.hsenergy.co.uk/help..
Unfortunately, we are not able to assist much in this department and would recommend reaching out to the manufacturer of your system. We are more than happy to do this on your behalf, but if you have the time to email them with your serial number (which can be found on the side of your system’s inverter) then they are able to help reset your password / login details.
Email for Solis: eu.service@solisinverters.com
Email for SoFar: uk.service@sofarsolar.com
Email for FOXESS: service.uk@fox-ess.com
Email for EcoFlow: solutionservice.eu@ecoflow.com